bike stalls in neutral starts right backup

BIKE STALLS IN NEUTRAL STARTS RIGHT BACKUP HOW TO

If you can’t get to the sparkplugs, the best way to get your bike to start up is by trying to have it turn over with your hand on wide open throttle. This is a really effective way, but what if the spark plugs are really hard to reach? The best way to go about this is removing your spark plugs, drying them off, and then putting them back in the bike. Like I mentioned earlier, it’s common to have a cylinder become flooded if your motorcycle is tipped over and it takes you a few minutes to bring it back up right.

BIKE STALLS IN NEUTRAL STARTS RIGHT BACKUP HOW TO

So let’s say that you knocked your motorcycle over and it won’t start, what do you do next? Sometimes bikes fall over in the least convenient spots, but luckily, getting your bike going again shouldn’t be too difficult.įirst, let’s look at how to fix your motorcycle if you suspect one of the cylinders is flooded. How To Fix A Motorcycle That Won’t Start After Falling Over So, in a condition where you don’t think it’s your fueling and/or the kill switch, check the connection that your motorcycle has to the battery. When a bike with a bad battery connection falls over, it wouldn’t be surprising if the impact caused the connection to shake loose. If corrosion on a battery becomes severe enough, the connection that is made on it can become fragile. On older bikes, or bikes that are kept outside, corrosion on battery terminals are normal, but should be regularly cleaned off. A major one is the connection that is made to the battery. There’s a lot of connections in a motorcycle that are needed in order for it to turn over. The kill switch is there as a safety net for the motorcycle, and if triggered, won’t allow it to restart until the switch is reset and the bike is upright.įinally, a no-start condition could be brought on by some disconnection in your motorcycle electronics if it is dropped. These switches are around so that if you are in an accident, or the bike falls while it is running and in gear, it’s not going to continue to run and possibly damage another motorist. On newer motorcycles, they have kill switches that detect whether it is standing up straight or lying of the ground. There are a lot of sensors on a bike, and the newer the bike, the more sensors you’re going to find. Other than having a flooded cylinder, another common reason a motorcycle won’t start is because of an internal switch that has malfunctioned. So, whether it was knocked over or not, the computer has to signal fuel to be delivered before it enters the cylinders. The reason this won’t happen to a fuel injected motor is because fuel is delivered and regulated by the computer. If too much fuel goes into any of the cylinders, the spark plug may have difficulty sparking because the connections on it are too wet from the gasoline. When a motorcycle is knocked over and fuel is sloshed around, sometimes too much fuel can be fed from the carburetor into the engine cylinders. As you all may know, the way a carbureted bike works is through getting gravity fed from the tank to the carburetor, and then from the carburetor it goes directly into the cylinders. This is going to be directly targeted at carbureted bike designs. The most common reason a motorcycle won’t start after falling is because of fuel delivery problems. To look at the reasons why a motorcycle won’t start, we will begin by looking at the most common causes. I’m sure that none of us want it to happen, but having your motorcycle fall over is only a question of when, meaning if you haven’t knocked it over yet, it’s really only a matter of time. Reasons Your Motorcycle Won’t Start After Falling Over Although there’s no way to fool proof a motorcycle to make sure it doesn’t fall over, we can take a look at a couple ways to make sure that yours stays upright as well as go into depth of why a it may not start if it falls and how you can fix it after it does. The only thing more embarrassing than having your bike knocked over is not being able to start it after it falls. The motorcycle may also have an internal switch that has malfunctioned or have a disconnection in the electronics because of the fall. Why won’t a motorcycle start after falling over? If a motorcycle won’t start after falling over, the biggest reason may be due to fuel delivery issues such as too much fuel leaking into the engine cylinders. It’s not uncommon for a motorcycle to struggle turning over when it has just been knocked down. Maybe your motorcycle is outside and the wind pushes it, or it’s in the garage and you accidentally bump it on your way out the door.Įither way, when your motorcycle gets knocked over, you might have bigger issues than just some scratched paint or bent brake levers. Generally, motorcycles sit on a tiny little kick stand on the left side, and knocking it over can be really easy.

Bike stalls in neutral starts right backup